SP Racing F3 Flight Control Card Acro - Betaflight
SP Racing F3 Flight Controller ARCO offers excellent flight performance based on tried and tested sensors, while a new generation CPU
Next-generation STM32 with hardware floating point unit for efficient flight calculations and faster ARM-Cortex M4 core Starting with the F3 processor, this flight controller has a lot of great features. There is a barometer mounted on the bottom of the panel for easy wind insulation, as well as additional internal sensors for altitude and heading. Dedicated output for programmable LEDs - perfect for steering, racing and night flying. Uncompromised I/O supports all features simultaneously.
F3 uses open source Betaflight flight control (BF) software, which has an ever-growing community of friendly developers and users . You can contribute to the system thanks to it being open source.
Pin Details:
4 x 4pin JST-SH sockets (I2C, SWD, 2xUART)
2 x 8pin JST-SH sockets (PPM, PWM, SERIAL RX, GPIO, ADC, 3V, 5V, GND)
8 x 3pin - holes for pin headers for ESC / Servo connections
2 x 4pin through holes for pin headers for 2x serial ports
2 x 2 pin through holes for pin headers for battery voltage and buzzer.
Features:
- Stackable - Connect to your PDB or OSD.
- Compact - Only 36x36mm.
- Professional - Symmetrical, Neat and Tidy.
- 8 Dedicated PWM outputs
- 8 PWM Inputs
- 36 I/O Connections
< li>72MHz Clock Speed - 3 Hardware Serial Ports
- 64 Mb Flash Storage
Configurable
SPRacingF3, platforms It runs Betaflight, which can be configured to meet your needs using a GUI (Windows / OSX / Linux).
Next Generation Processor
SPRacingF3, less It features an ARM Cortex-M4 72MHz CPU with Math co-processor (FPU) for efficient in-flight calculations that get more done in time.
Cycling is up to ~2x speeds over previous generation STM32F1-based boards.
OneShot ESC
Full support for OneShot ESCs for easy PID tuning and clearer response.
Wide RC receiver Support
Supports SBus, SumH, SumD, Spektrum1024 / 2048, XBus, PPM, PWM receivers. No external inverter required (built-in).
Programmable led
Special output for programmable LEDs - ideal for steering, racing and night flying.< /div>
Battery Monitoring
Battery monitoring ports for voltage and current.
Sonar< /h4>
Sonar support for precise low altitude hold.
I2C Port
The I2C port is always strong, for external sensors or Perfect for always-on OLED Display.
Buzzer
Audio port for audio alerts and notifications.
Features:
- STM32F3 CPU, MPU 6500 sensor, 16M high-capacity flash memory
- SP F3, cross-platform GUI (Windows / OSX / Linux It runs Betaflight, which can be configured to your needs using .
- Small and lightweight, the Racing F3 has a standard 36x36mm form factor with 30.5mm mounting holes and weighs just 6 grams.
- Flight Log, built-in high-capacity black box flight log recorder - optimize your settings and see the results of your setup without the guesswork.
- Wide RC receiver supports SBus, SumH, SumD, Spektrum1024/2048, XBus, PPM, PWM receivers, external inverter not required (internal).
- Programmable LED, a dedicated output for programmable LEDs - great for steering, racing and night flying.
- Battery Monitoring, battery monitoring ports for voltage and current .
- Sonar support for precise low altitude hold.
- I2C port is always strong, perfect for external sensors or always-on OLED Display.
< /div>
.png)
